6mm Tungsten Carbide Evacuable Die
Part Number 3070TC
Precision manufactured and includes hardened 440C stainless steel die components (main body, a removable base with a vacuum attachment and plunger), polished tungsten carbide anvils (2), vacuum o-rings (2), extractor ring and operating instructions.
Die Chamber Height Without Sample: 31mm
Each Die Anvil Thickness: 5.50mm
Maximum Height In Die Chamber For Uncompressed Sample Matrix Using Two Anvils: 14mm
(accounts for locating die plunger 6mm into die chamber)
Maximum Height In Die Chamber For Uncompressed Sample Matrix Using One Anvil: 19.50mm
(accounts for locating die plunger 6mm into die chamber)
Maximum Load: 2 Tons
Tips
- preferred for powdered abrasives, ceramics and hard mineral-like materials
- typically the sample pellet is fabricated between two anvils although one anvil can be used
to fabricate a thicker sample pellet.
- allow 6mm minimum to locate the die plunger into the die chamber in order to follow the die
chamber wall.
- the evacuable design feature with the use of an
oil-less vacuum pump permits easy installation of anvils and plunger without the vacuum resistance normally associated with non-evacuable dies due to the precision fabrication and tight tolerances to mitigate
flashing of the powdered sample matrix during pellet fabrication.
Operating Instructions
CLICK HERE
